Page 86 - LIT-18626-14-66

SportsBoat_F5K13.book Page 78 Tuesday, June 13, 2023 5:43 PM

Instrument operation

To deactivate the cruise assist: “CRUISE/NO WAKE” (+) button or
Operate the remote control levers to de- “CRUISE/NO WAKE” (–) button.
crease the engine speed to 3000 rpm or less. To deactivate the no-wake mode:
When “Cruise” and the cruise assist setting Perform one of the following operations.
level disappear, the cruise assist is deactivat-  Push the “CRUISE/NO WAKE” (–) button
ed. repeatedly until “No Wake” disappears.
 Push the remote control levers forward to
Operating the boat with a minimal open the throttle.
wake (no-wake mode)
The no-wake mode is useful for operating the Operating the boat in reverse with
boat at a steady speed with a minimal wake. more thrust (reverse RPM control)
This is especially convenient when traveling Engine speed in reverse is limited to approx-
in harbors, channels, or other areas posted imately 4500 rpm. If more thrust is required
with low speed limits as “no wake zones”. when the boat is traveling in reverse, use the
The no-wake mode can be activated only reverse RPM control. WARNING! Be pre-
when the engines are operating at idle speed. pared to reduce throttle as soon as the
To activate the no-wake mode: boat moves as desired. Otherwise, the
(1) Put the remote control levers in the TDE boat may become unstable, which could
position or forward position so that both result in loss of control and an accident.
engines are operating at idle speed. To activate the reverse RPM control:
(2) Push the “CRUISE/NO WAKE” (+) but- (1) Move the remote control levers back-
ton. When the no-wake mode is activat- ward so that the throttle is opened in re-
ed, “No Wake” and the no-wake mode verse and both engines are operating at
setting level will be displayed under the the same engine speed.
boat speed. (2) Increase the engine speed to 4500 rpm,
and then push the “CRUISE/NO WAKE”
SE S SW (+) button.
Once the reverse RPM control is activated,
pushing the “CRUISE/NO WAKE” (+) button
will increase the available engine speed by
approximately 500 rpm in 3 stages up to a
MPH maximum of 6000 rpm, and pushing the
“CRUISE/NO WAKE” (–) button will decrease
No Wake:
the available engine speed. However, the ad-
1 justment is limited to these 3 increments.
To deactivate the reverse RPM control:
1 No-wake mode setting level
Operate the remote control levers to de-
crease the engine speed to less than 4500
The no-wake mode can be set to 3 engine
rpm.
speeds. To adjust the engine speed while the
no-wake mode is activated, push the

78