Page 91 - LIT-18626-14-73

SportsBoat_F5K14.book Page 82 Wednesday, September 6, 2023 2:56 PM

Instrument operation

To deactivate the cruise assist: “CRUISE/NO WAKE” (+) button or
Operate the remote control levers to de- “CRUISE/NO WAKE” (–) button.
crease the engine speed to 3000 rpm or less. To deactivate the no-wake mode:
When “Cruise” and the cruise assist setting Perform one of the following operations.
level disappear, the cruise assist is deactivat-  Push the “CRUISE/NO WAKE” (–) button
ed. repeatedly until “No Wake” disappears.
 Push the remote control levers forward to
Operating the boat with a minimal open the throttle.
wake (no-wake mode)
The no-wake mode is useful for operating the TIP:
boat at a steady speed with a minimal wake. 252SD / 255XD: If the throttle/shift paddles
This is especially convenient when traveling are operated in the DRiVE X mode while the
in harbors, channels, or other areas posted no-wake mode is activated, the no-wake
with low speed limits as “no wake zones”. mode will be deactivated.
The no-wake mode can be activated only
when the engines are operating at idle speed. Operating the boat in reverse with
To activate the no-wake mode: more thrust (reverse RPM control)
(1) Put the remote control levers in the TDE Engine speed in reverse is limited to approx-
position or forward position so that both imately 4500 rpm. If more thrust is required
engines are operating at idle speed. when the boat is traveling in reverse, use the
(2) Push the “CRUISE/NO WAKE” (+) but- reverse RPM control. WARNING! Be pre-
ton. When the no-wake mode is activat- pared to reduce throttle as soon as the
ed, “No Wake” and the no-wake mode boat moves as desired. Otherwise, the
setting level will be displayed under the boat may become unstable, which could
boat speed. result in loss of control and an accident.
To activate the reverse RPM control:
SE S SW (1) Move the remote control levers back-
ward so that the throttle is opened in re-
verse and both engines are operating at
the same engine speed.
(2) Increase the engine speed to 4500 rpm,
MPH and then push the “CRUISE/NO WAKE”
No Wake: (+) button.
Once the reverse RPM control is activated,
1 pushing the “CRUISE/NO WAKE” (+) button
will increase the available engine speed by
1 No-wake mode setting level
approximately 500 rpm in 3 stages up to a
The no-wake mode can be set to 3 engine maximum of 6000 rpm, and pushing the
speeds. To adjust the engine speed while the “CRUISE/NO WAKE” (–) button will decrease
no-wake mode is activated, push the the available engine speed. However, the ad-
justment is limited to these 3 increments.

82