Page 61 - LIT-18626-14-67
P. 61
SportsBoat_F7G10.book Page 52 Wednesday, June 14, 2023 9:23 AM
Instrument operation
To activate the cruise assist:
(1) Push the remote control levers forward
to open the throttle until the desired en-
gine speed is reached.
(2) Push the plus side or minus side of the
no-wake mode/cruise assist switch.
Once “CRUISE ASSIST” and the cruise assist
1 setting level are displayed in the multifunction
display, the cruise assist is activated.
SE S SW
1 Switch circuit breaker
No-wake mode / cruise assist switch
This switch activates and sets the no-wake
mode, cruise assist, and reverse RPM con-
trol. MPH
CRUISE ASSIST:
1
1 1 Cruise assist setting level
TIP:
Once the cruise assist is activated, the set
engine speed can be increased by pushing
the plus side of the switch or decreased by
pushing the minus side. However, the ad-
1 No-wake mode / cruise assist switch justment is limited to a maximum of 8 incre-
ments above or below the initial cruise
To operate the no-wake mode and cruise as- assist setting. Each time the switch is
sist, see the following sections. To activate pushed, the engine speed will increase or
the reverse RPM control, see “Reverse RPM decrease approximately 100–200 rpm.
control” on page 53. While the cruise assist is activated, the en-
gine speed can also be adjusted by operat-
Operating the boat at a steady speed ing the remote control levers.
(cruise assist)
The cruise assist feature is for steady engine To deactivate the cruise assist:
speed operation when the boat is traveling Operate the remote control levers to de-
above no-wake speeds. The cruise assist is crease the engine speed to 3000 rpm or less.
available for use whenever the engine is run- Once “CRUISE ASSIST” and the cruise assist
ning above 3000 rpm and below 7000 rpm. setting level disappear, the cruise assist is
deactivated.
52