Page 100 - LIT-18626-14-04

SportsBoat_F4V14.book Page 92 Tuesday, July 5, 2022 2:34 PM

Equipment operation

(7) While pulling the main pole down, push If a boat cover is not used, wrap an elastic
the snap button and shorten each rear cord around the top and secure the ends to
support pole to either the middle position the tow pylon on the wakeboard tower to re-
for cruising or to the short position if you strict movement.
are using the wakeboard tower. Be sure
the snap buttons click into place. Removing the bimini top
To remove the bimini top:
(1) Store the bimini top. See “Storing the bi-
1 mini top”.
(2) While supporting the bimini top, remove
2
the lock pins securing the main pole to
3 the wakeboard tower, and then remove
the top.
4
1

1 Rear support pole
2 Short position
3 Middle position
4 Snap button

NOTICE 2
 Do not exceed 72 km/h (45 mph) with the
1 Bimini top
bimini top in the up position.
2 Lock pin
 Be careful not to push the snap button
and extend the pole too far. Otherwise,
Installing the bimini top
the lower section of the pole could fall
To install the bimini top:
into the water.
When installing the bimini top, simply reverse
the removal steps, and then make sure that
Storing the bimini top the lock pins are securely installed.
To store the bimini top:
When storing the bimini top, simply reverse
the steps for setting it up.

Trailering with the bimini top
The bimini top must be secured to the boat
when it is being trailered. When the boat is
trailered with a genuine Yamaha boat cover,
simply store the bimini top in the fully col-
lapsed position and install the storage cover.

92