Page 221 - LIT-18626-14-67

SportsBoat_F7G10.book Page 212 Wednesday, June 14, 2023 9:23 AM

Trouble recovery

2
1
1
3

1 Access port cap 1 “SET” mark
2 Slot A
(5) Remove any weeds or debris from the 3 Slot B
drive shaft, impeller, pump housing, and
jet thrust nozzle. If you cannot remove (8) Check that the cap is parallel to the cen-
the debris, consult a Yamaha Boat Deal- terline of the boat. Pull the handle force-
er. fully to make sure that the cap is locked
(6) To reinstall the access port cap, first securely. If a strong pull will move the ac-
clean off any sand or other foreign matter cess port cap, it is not locked securely—
from the cap or port surfaces. Apply a the cap could be forced out by water
light coat of Yamalube Waterproof Ma- pressure during operation.
rine Grease (P/N: ACC-GREAS-10-CT), if 1
available, to the seal of the access port
cap. If grease is not available, apply the
grease during the post-operation
checks.
(7) Insert the cap so that the “SET” mark is
aligned with the slot A, and then while
pushing the handle turn the cap clock-
wise until the “SET” mark is aligned with
the slot B.
1 Parallel to the centerline of the boat

(9) Close the rear platform hatch.
NOTICE
Be sure the access port caps are locked
securely in place. Otherwise, the caps
could be forced out of the access ports by
water pressure, causing loss of perfor-
mance and possible damage.

212