Page 177 - LIT-18626-14-67

SportsBoat_F7G10.book Page 168 Wednesday, June 14, 2023 9:23 AM

Pre-operation checks

222SE / 222SD / 222XE / 222XD

1

2

1 Engine shut-off switch
Post-launch checks
2 Clip
Perform the post-launch checks in the pre-
operation checklist while the boat is in the
Cooling water pilot outlet check
water and the engines are running.
Check that water comes out from the pilot
outlets while the engines are running in the
Engine shut-off switch check
water. If water is not circulating, something
Check the engine shut-off switch for proper
may be clogging the intake grates. Refer to
operation.
“Jet pump clean-out procedure” on page
(1) Start the engines. (See page 170 for in-
211.
formation on starting the engines.)
(2) Pull the engine shut-off cord (lanyard) to
remove the clip from the engine shut-off
switch to make sure that the engines
stop immediately.
(3) Make sure that the engines cannot be
started with the clip removed from the
engine shut-off switch.
AR220 / SX220 / 222S

TIP:
It may take up to 20 seconds for water to
1
reach the pilot outlets when first launching
the boat. The amount and force of the exiting
2 water will vary with engine speed.
NOTICE
A continuous flow of water from the pilot
outlets shows that water is flowing
1 Engine shut-off switch
through the engine cooling water passag-
2 Clip
es. If water is not flowing out of the pilot
168