Page 162 - LIT-18626-14-67

SportsBoat_F7G10.book Page 153 Wednesday, June 14, 2023 9:23 AM

Operation and handling requirements

1900 cc engine models Draining the bilge water
NOTICE

 Do not run the engines at full throttle
when bilge water remains in the engine
1 compartment. The bilge water can
splash into the engines, which can result
in severe damage.
 Be sure all drain plugs are tightened be-
fore operating your boat. Otherwise,
water may flood the boat and cause it to
1 Engine oil filler cap submerge.
(7) Slowly add engine oil.
(8) Wait approximately 5 minutes to allow Draining the bilge water on land
the engine oil to settle, and then check This model is equipped with multiple drain
the engine oil level again. plugs.
(9) Repeat steps 3–8 until the engine oil is at Bilge water from the various compartments
the proper level. flows through drain passages and collects in
(10) Install the engine oil filler cap. the bottom of the hull. The bilge water can be
(11) Repeat the checking oil level procedure drained from the boat by removing the hull
for the other engine. drain plugs.
(12) Close the engine hood.
Engine compartment

1

1 Engine compartment drain plug
To drain the bilge water from the hull:
Remove the hull drain plug at the stern to
drain the water. Check the condition of the
O-ring on the hull drain plug, and then se-
curely install the drain plug.

153