Page 104 - LIT-18626-14-67

SportsBoat_F7G10.book Page 95 Wednesday, June 14, 2023 9:23 AM

Instrument operation

available for use whenever the engines are To deactivate the cruise assist:
running above 3000 rpm and below 7000 Operate the remote control levers to de-
rpm. crease the engine speed to 3000 rpm or less.
To activate the cruise assist: When “CRUISE ASSIST” and the cruise as-
(1) Push the remote control levers forward sist setting level disappear, the cruise assist
to open the throttle until the desired en- is deactivated.
gine speed is reached and both engines
are operating at the same engine speed. Operating the boat with a minimal
(2) Push the “CRUISE/NO WAKE” (+) button wake (no-wake mode)
or “CRUISE/NO WAKE” (–) button. When The no-wake mode is useful for operating the
the cruise assist is activated, “CRUISE boat at a steady speed with a minimal wake.
ASSIST” and the cruise assist setting This is especially convenient when traveling
level will be displayed under the boat in harbors, channels, or other areas posted
speed. with low speed limits as “no wake zones”.
The no-wake mode can be activated only
SE S SW when the engines are operating at idle speed.
To activate the no-wake mode:
(1) Put the remote control levers in the TDE
position or forward position so that both
engines are operating at idle speed.
MPH (2) Push the “CRUISE/NO WAKE” (+) but-
ton. When the no-wake mode is activat-
CRUISE ASSIST:
ed, “No Wake” and the no-wake mode
1 setting level will be displayed under the
boat speed.
1 Cruise assist setting level
SE S SW
 Once the cruise assist is activated, the set
engine speed can be increased by pushing
the “CRUISE/NO WAKE” (+) button or de-
creased by pushing the “CRUISE/NO
WAKE” (–) button. However, the adjust-
ment is limited to a maximum of 8 incre- MPH
ments above or below the initial cruise No Wake:
assist setting. Each time a button is
pushed, the engine speed will increase or 1
decrease approximately 100–200 rpm. 1 No-wake mode setting level
 While the cruise assist is activated, the en-
gine speed can also be adjusted by operat- The no-wake mode can be set to 3 engine
ing the remote control levers. speeds. To adjust the engine speed while the
no-wake mode is activated, push the

95