Page 82 - LIT-18626-12-95

Instrument operation

running above 3000 rpm and below 7000 When “Cruise” and the cruise assist setting
rpm. level disappear, the cruise assist is deactivat-
To activate the cruise assist: ed.
(1) Push the remote control levers forward
to open the throttle until the desired en- Operating the boat with a minimal
gine speed is reached and both engines wake (no-wake mode)
are operating at the same engine speed. The no-wake mode is useful for operating the
(2) Push the “CRUISE/NO WAKE” (+) button boat at a steady speed with a minimal wake.
or “CRUISE/NO WAKE” (–) button. When This is especially convenient when traveling
the cruise assist is activated, “Cruise” in harbors, channels, or other areas posted
and the cruise assist setting level will be with low speed limits as “no wake zones”.
displayed under the boat speed. The no-wake mode can be activated only
when the engines are operating at idle speed.
SE S SW To activate the no-wake mode:
(1) Put the remote control levers in the TDE
position or forward position so that both
engines are operating at idle speed.
(2) Push the “CRUISE/NO WAKE” (+) but-
MPH ton. When the no-wake mode is activat-
ed, “No Wake” will be displayed under
Cruise +4
the boat speed.
1
SE S SW
1 Cruise assist setting level
z Once the cruise assist is activated, the set
engine speed can be increased by pushing
the “CRUISE/NO WAKE” (+) button or de-
creased by pushing the “CRUISE/NO MPH
WAKE” (–) button. However, the adjust- No Wake
ment is limited to a maximum of 8 incre-
ments above or below the initial cruise 1
assist setting. Each time a button is 1 “No Wake”
pushed, the engine speed will increase or
decrease approximately 100–200 rpm. The no-wake mode can be set to 3 engine
z While the cruise assist is activated, the en- speeds. To adjust the engine speed while the
gine speed can also be adjusted by operat- no-wake mode is activated, push the
ing the remote control levers. “CRUISE/NO WAKE” (+) button or
“CRUISE/NO WAKE” (–) button.
To deactivate the cruise assist: To deactivate the no-wake mode:
Operate the remote control levers to de- Perform one of the following operations.
crease the engine speed to 3000 rpm or less.

74