Page 49 - LIT-18626-13-46

SportsBoat_F4X13.book Page 42 Friday, May 21, 2021 4:49 PM

Instrument operation

Operating the boat with a minimal wake TIP:
(no-wake mode) 275SD: If the throttle/shift paddles are oper-
The no-wake mode is useful for operating the ated in the DRiVE mode while the no-wake
boat at a steady speed with a minimal wake. mode is activated, the no-wake mode will be
This is especially convenient when traveling deactivated.
in harbors, channels, or other areas posted
with low speed limits as “no wake zones”. Operating the boat in reverse with more
The no-wake mode can be activated only thrust (reverse RPM control)
when the engines are operating at idle speed. Engine speed in reverse is limited to approx-
To activate the no-wake mode: imately 4500 rpm. If more thrust is required
(1) Put the remote control levers in the TDE when the boat is traveling in reverse, use the
position or forward position so that both reverse RPM control. WARNING! Be pre-
engines are operating at idle speed. pared to reduce throttle as soon as the
(2) Push the “CRUISE/NO WAKE” (+) but- boat moves as desired. Otherwise, the
ton. When the no-wake mode is activat- boat may become unstable, which could
ed, “No Wake” will be displayed under result in loss of control and an accident.
the boat speed. To activate the reverse RPM control:
(1) Move the remote control levers back-
NW N NE ward so that the throttle is opened in re-
verse and both engines are operating at
SPEED the same engine speed.
(2) Increase the engine speed to 4500 rpm,
and then push the “CRUISE/NO WAKE”
MPH
(+) button.
No Wake Once the reverse RPM control is activated,
pushing the “CRUISE/NO WAKE” (+) button
1 will increase the available engine speed by
approximately 500 rpm in 3 stages up to a
1 “No Wake”
maximum of 6000 rpm, and pushing the
The no-wake mode can be set to 3 engine “CRUISE/NO WAKE” (–) button will decrease
speeds. To adjust the engine speed while the the available engine speed. However, the ad-
no-wake mode is activated, push the justment is limited to these 3 increments.
“CRUISE/NO WAKE” (+) button or To deactivate the reverse RPM control:
“CRUISE/NO WAKE” (–) button. Operate the remote control levers to de-
To deactivate the no-wake mode: crease the engine speed to less than 4500
Perform one of the following operations. rpm.
 Push the “CRUISE/NO WAKE” (–) button
repeatedly until “No Wake” disappears.
 Push the remote control levers forward to
open the throttle.

42