Page 116 - LIT-18626-15-33

SportsBoat_F6A12.book Page 105 Thursday, May 30, 2024 4:19 PM

Pre-operation checks

(1) Start the engines. (See page 107 for in- “Jet pump clean-out procedure” on page
formation on starting the engines.) 140.
(2) Pull the engine shut-off cord (lanyard) to
remove the clip from the engine shut-off
switch to make sure that the engines
stop immediately.
(3) Make sure that the engines cannot be
started with the clip removed from the
engine shut-off switch.
220 FSH SPORT / 222 FSH SPORT

BLOWER
TIP:
It may take up to 20 seconds for water to
reach the pilot outlets when first launching
1 the boat. The amount and force of the exiting
water will vary with engine speed.
2 NOTICE
A continuous flow of water from the pilot
1 Engine shut-off switch outlets shows that water is flowing
2 Clip
through the engine cooling water passag-
es. If water is not flowing out of the pilot
222 FSH SPORT E
outlets during operation, do not continue
to run the engines. Overheating and seri-
ous damage could occur. (See “Over tem-
1 perature warning” on page 53 for more
information.)

2
Fuel level check
Check the amount of fuel remaining in the
fuel tank using the fuel level bar graph on the
multi-function display.
1 Engine shut-off switch
2 Clip

Cooling water pilot outlet check
Check that water comes out from the pilot
outlets while the engines are running in the
water. If water is not circulating, something
may be clogging the intake grates. Refer to

105