Page 115 - LIT-18626-15-32

SportsBoat_F6H15.book Page 105 Tuesday, June 4, 2024 5:17 PM

Pre-operation checks

(1) Start the engines. (See page 107 for in-
1 formation on starting the engines.)
(2) Pull the engine shut-off cord (lanyard) to
remove the clip from the engine shut-off
switch to make sure that the engines
AFT RAW WATER FRESHWATER BILGE HORN
LIVEWELL WASHDOWN WASHDOWN stop immediately.
(3) Make sure that the engines cannot be
started with the clip removed from the
engine shut-off switch.
252 FSH SPORT
1 Horn switch

Engine shut-off cords (lanyards) 1
check
Make sure that the engine shut-off cords (lan-
yards) are not damaged. If the cord is dam-
aged, replace it. WARNING! Never try to
repair the engine shut-off cord (lanyard) or
tie it together. The engine shut-off cord 2
(lanyard) may not pull free when the oper-
ator falls off, allowing the boat to continue 1 Engine shut-off switch
to run and cause an accident. 2 Clip
255 FSH SPORT E / 255 FSH SPORT H

1

2

Post-launch checks
Perform the post-launch checks in the pre- 1 Engine shut-off switch
operation checklist while the boat is in the 2 Clip
water and the engines are running.
Cooling water pilot outlet check
Engine shut-off switch check Check that water comes out from the pilot
Check the engine shut-off switch for proper outlets while the engines are running in the
operation. water. If water is not circulating, something
may be clogging the intake grates. Refer to

105