Page 102 - LIT-18626-15-32
P. 102

SportsBoat_F6H15.book  Page 92  Tuesday, June 4, 2024  5:17 PM



                        Operation and handling requirements

                        255 FSH SPORT E / 255 FSH SPORT H         Draining the bilge water
                                                              NOTICE
                                                 1
                                                               Do  not  run the engines at  full throttle
                                                               when bilge water remains in the engine
                                                               compartment. The bilge water can
                                                               splash into the engines, which can result
                                                               in severe damage.
                                                               Be sure all drain plugs are tightened be-
                                                               fore operating your boat. Otherwise,
                                                               water may flood the boat and cause it to
                        1  Engine oil filler cap               submerge.
                        (7) Slowly add engine oil.
                        (8) Wait approximately  5 minutes to allow  Draining the bilge water on land
                            the engine oil to settle, and then check  This model is equipped with the hull drain
                            the engine oil level again.       plug.
                        (9) Repeat steps 3–8 until the engine oil is at  Engine compartment
                            the proper level.
                        (10) Install the engine oil filler cap.
                        (11) Repeat the checking oil level procedure
                            for the other engine.
                        (12) Close the engine hood.
                                                                                         1






                                                              1  Engine compartment drain plug

                                                              To drain the bilge water from the hull:
                                                              Remove the  hull drain plug at  the stern  to
                                                              drain the water. Check the condition of the















                        92
   97   98   99   100   101   102   103   104   105   106   107