Page 123 - LIT-18626-15-31
P. 123

SportsBoat_F7H11.book  Page 112  Wednesday, May 29, 2024  3:03 PM



                                                                Pre-operation checks



                                           2
                                                        4
                                              3
                                                                                              1
                          1







                        1  Negative (–) battery terminal      1  Hull drain plug
                        2  Black lead
                        3  Positive (+) battery terminal      Blower check
                        4  Red lead
                                                                  WARNING
                        Bilge water check                     Gasoline vapors  can explode. Before
                        Make sure that no bilge water has collected in  starting the engine, check the engine
                        the engine compartment. If bilge water has  compartment for  gasoline, gasoline va-
                        collected in the engine compartment, drain it.  pors, and loose electrical connections,
                        (See page 102 for information on draining the  and then operate the blower for at least 4
                        bilge water.)                         minutes. Do not start the engine or oper-
                                                              ate the blower  if  you can smell gasoline
                        Drain plug check                      vapors in the engine compartment or if
                        Loosen the drain plugs and  remove  them,  there are any loose electrical connections.
                        and then make sure that the plugs and the O-  Contact a Yamaha Boat Dealer if there is a
                        rings on the hull drain plugs are not damaged  problem you cannot locate or correct.
                        and that there is no foreign material on the
                                                              Make sure that the blower operates properly
                        threads or the O-rings on the hull drain plugs.
                                                              when the blower switch is pushed.
                        NOTICE: Before installing the drain plugs,
                        clean the drain plug threads and the
                        O-rings on the hull drain plugs to remove
                        any foreign materials, such as dirt or sand.
                        Otherwise, the drain plugs could be dam-  1    BLOWER
                        aged, allowing water to enter the engine
                        compartment or the fuel tank  compart-
                        ment. Make sure that the drain plugs are
                        tightened securely  before launching the
                        boat. Otherwise, water may flood the boat
                        and cause it to submerge.
                        Securely install the drain plugs by tightening  1  Blower switch
                        them until they stop.



                                                                                             112
   118   119   120   121   122   123   124   125   126   127   128