Page 54 - LIT-18626-15-30

SportsBoat_F7G11.book Page 42 Friday, May 24, 2024 6:06 PM

Control function operation

Boat control functions AR220 / SX220 / 222S
Engine shut-off switch
WARNING
 Always attach the engine shut-off cord 1
(lanyard) to your PFD before starting the
engines. Failure to attach the cord could
result in a runaway boat if the operator is 2
ejected.
 Do not attach the cord to clothing that 3
could tear loose. Do not route the cord
in such a way that it could become en- 1 Engine shut-off switch
tangled, preventing it from functioning. 2 Clip
 Avoid accidentally pulling the cord dur- 3 Engine shut-off cord (lanyard)
ing normal operation. Once the engines
222SE / 222SD
have stopped, you have no steering con-
trol of the boat which could result in an
accident. Also, without engine power,
the boat could slow rapidly from planing 1
speed. This could cause people and ob-
jects in the boat to be thrown forward,
which could cause injury. 2
The clip on the end of the engine shut-off
cord (lanyard) must be attached to the engine 3
shut-off switch for the engines to run. The
cord must be attached to a secure place on 1 Engine shut-off switch
the operator’s PFD. Should the operator fall 2 Clip
overboard or leave the helm, the cord will pull 3 Engine shut-off cord (lanyard)
out the clip, stopping the ignition to the both
engines. This will prevent the boat from run- TIP:
ning away under power. It is recommended that a spare engine shut-
off cord (lanyard) be stored in a storage com-
partment near the driver’s seat to allow a
passenger to restart the vessel if the operator
falls overboard.

Batteries and battery switches
The batteries are located in the engine com-
partment.
This boat uses two marine batteries. One bat-
tery is designated as the start battery. The

42