Page 112 - LIT-18626-14-72

SportsBoat_F6H14.book Page 105 Thursday, August 17, 2023 4:57 PM

Pre-operation checks

(2) Pull the engine shut-off cord (lanyard) to
1 remove the clip from the engine shut-off
switch to make sure that the engines
stop immediately.
(3) Make sure that the engines cannot be
AFT RAW WATER FRESHWATER BILGE HORN
LIVEWELL WASHDOWN WASHDOWN started with the clip removed from the
engine shut-off switch.
252 FSH SPORT

1 Horn switch 1

Engine shut-off cord (lanyard) check
Make sure that the engine shut-off cord (lan-
yard) is not damaged. If the cord is damaged,
replace it. WARNING! Never try to repair
the engine shut-off cord (lanyard) or tie it 2
together. The engine shut-off cord (lan-
yard) may not pull free when the operator 1 Engine shut-off switch
falls off, allowing the boat to continue to 2 Clip
run and cause an accident.
255 FSH SPORT E / 255 FSH SPORT H

1

2

Post-launch checks 1 Engine shut-off switch
Perform the post-launch checks in the pre- 2 Clip
operation checklist while the boat is in the
water and the engines are running. Cooling water pilot outlet check
Check that water comes out from the pilot
Engine shut-off switch check outlets while the engines are running in the
Check the engine shut-off switch for proper water. If water is not circulating, something
operation. may be clogging the intake grates. Refer to
(1) Start the engines. (See page 107 for in- “Jet pump clean-out procedure” on page
formation on starting the engines.) 143.

105