Page 4 - LIT-18626-14-66

SportsBoat_F5K13.book Page 2 Tuesday, June 13, 2023 5:43 PM

Important manual information

FCC Compliance RF Exposure Compliance
This device complies with part 15 of the FCC This equipment complies with FCC radiation
Rules. Operation is subject to the following exposure limits set forth for an uncontrolled
two conditions: (1) this device may not cause environment and meets the FCC radio fre-
harmful interference, and (2) this device must quency (RF) Exposure Guidelines as this
accept any interference received, including equipment has very low levels of RF energy.
interference that may cause undesired oper-
ation.
AR250 / SX250
This equipment has been tested and found to
252S / 252SE / 252XE / 255XE
comply with the limits for a Class B digital de- OWNER’S/OPERATOR’S MANUAL
vice, pursuant to part 15 of the FCC rules. ©2024 by Yamaha Motor Corporation,
These limits are designed to provide reason- U.S.A.
able protection against harmful interference 1st Edition, May 2023
All rights reserved.
in a residential installation. This equipment
Any reprinting or unauthorized use
generates, uses, and can radiate radio fre- without the written permission of
quency energy and may cause harmful inter- Yamaha Motor Corporation, U.S.A.
ference to radio communications if not is expressly prohibited.
installed and used in accordance with the in- Printed in U.S.A.
P/N LIT-18626-14-66
structions. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television re-
ception, which can be determined by turning
the equipment off and on, the user is encour-
aged to try to correct the interference by one
of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the
equipment and the receiver.
 Connect the equipment into an outlet that
is on a different circuit from the GPS de-
vice.
 Consult the dealer or an experienced ra-
dio/TV technician for help.

FCC CAUTION
Changes or modifications not expressly ap-
proved by the party responsible for compli-
ance could void the user’s authority to
operate the equipment.