Page 96 - LIT-18626-14-08

SportsBoat_F6A10.book Page 89 Tuesday, March 7, 2023 8:39 AM

Operation and handling requirements

level is below the minimum level mark, Draining the bilge water
add engine oil. NOTICE
(6) Remove the engine oil filler cap.
 Do not run the engines at full throttle
when bilge water remains in the engine
1 compartment. The bilge water can
splash into the engines, which can result
in severe damage.
 Be sure all drain plugs are tightened be-
fore operating your boat. Otherwise,
water may flood the boat and cause it to
submerge.

1 Engine oil filler cap Draining the bilge water on land
This model is equipped with multiple drain
(7) Slowly add engine oil.
plugs.
(8) Wait approximately 5 minutes to allow
Bilge water from the various compartments
the engine oil to settle, and then check
flows through drain passages and collects in
the engine oil level again.
the bottom of the hull. The bilge water can be
(9) Repeat steps 3–8 until the engine oil is at
drained from the boat by removing the hull
the proper level.
drain plug.
(10) Install the engine oil filler cap.
Engine compartment
(11) Repeat the checking oil level procedure
for the other engine.
(12) Close the engine hood.
1

1 Engine compartment drain plug

89