Page 109 - LIT-18626-14-08

SportsBoat_F6A10.book Page 102 Tuesday, March 7, 2023 8:39 AM

Pre-operation checks

To check the operation using the navigation Engine shut-off cord (lanyard) check
and anchor lights switch: Make sure that the engine shut-off cord (lan-
(1) Push the upper side of the navigation yard) is not damaged. If the cord is damaged,
and anchor lights switch and check that replace it. WARNING! Never try to repair
the bow light and anchor light come on. the engine shut-off cord (lanyard) or tie it
together. The engine shut-off cord (lan-
1 yard) may not pull free when the operator
falls off, allowing the boat to continue to
run and cause an accident.

NAV/ANC CTSY MAP SPREADER
LIGHTS LIGHTS LIGHTS

1 Navigation and anchor lights switch

(2) Push the lower side of the navigation and
anchor lights switch and check that only
the anchor light comes on. Post-launch checks
(3) Put the navigation and anchor lights Perform the post-launch checks in the pre-
switch in the middle position and check operation checklist while the boat is in the
that the bow light and anchor light are water and the engines are running.
off.
Engine shut-off switch check
Horn switch check Check the engine shut-off switch for proper
Push the horn switch and check that the horn operation.
sounds. (1) Start the engines. (See page 105 for in-
formation on starting the engines.)
1 (2) Pull the engine shut-off cord (lanyard) to
remove the clip from the engine shut-off
switch to make sure that the engines
stop immediately.
ACC 1 ACC 2 LIVEWELL BILGE HORN
(3) Make sure that the engines cannot be
started with the clip removed from the
engine shut-off switch.

1 Horn switch

102