Page 92 - LIT-18626-13-51

SportsBoat_F6H11.book Page 85 Friday, May 21, 2021 4:25 PM

Operation and handling requirements

(6) Remove the engine oil filler cap. Draining the bilge water
NOTICE
1
 Do not run the engines at full throttle
when bilge water remains in the engine
compartment. The bilge water can
splash into the engines, which can result
in severe damage.
 Be sure all drain plugs are tightened be-
fore operating your boat. Otherwise,
water may flood the boat and cause it to
submerge.
1 Engine oil filler cap
(7) Slowly add engine oil. Draining the bilge water on land
(8) Wait approximately 5 minutes to allow
This model is equipped with the hull drain
the engine oil to settle, and then check
plug.
the engine oil level again.
Engine compartment
(9) Repeat steps 3–8 until the engine oil is at
the proper level.
(10) Install the engine oil filler cap.
(11) Repeat the checking oil level procedure
for the other engine.
(12) Close the engine hood. 1

1 Engine compartment drain plug
To drain the bilge water from the hull:
Remove the hull drain plug at the stern to
drain the water. Check the condition of the

85