Page 82 - LIT-18626-13-49

SportsBoat_F3R15.book Page 73 Friday, May 14, 2021 11:12 AM

Instrument operation

When “Cruise” and the cruise assist setting To deactivate the no-wake mode:
level disappear, the cruise assist is deactivat- Perform one of the following operations.
ed.  Push the “CRUISE/NO WAKE” (–) button
repeatedly until “No Wake” disappears.
Operating the boat with a minimal  Push the remote control levers forward to
wake (no-wake mode) open the throttle.
The no-wake mode is useful for operating the
boat at a steady speed with a minimal wake. Operating the boat in reverse with
This is especially convenient when traveling more thrust (reverse RPM control)
in harbors, channels, or other areas posted Engine speed in reverse is limited to approx-
with low speed limits as “no wake zones”. imately 4500 rpm. If more thrust is required
The no-wake mode can be used only when when the boat is traveling in reverse, use the
the engines are operating at idle speed. reverse RPM control. WARNING! Be pre-
To activate the no-wake mode: pared to reduce throttle as soon as the
(1) Put the remote control levers in the TDE boat moves as desired. Otherwise, the
position or forward position so that both boat may become unstable, which could
engines are operating at idle speed. result in loss of control and an accident.
(2) Push the “CRUISE/NO WAKE” (+) but- To activate the reverse RPM control:
ton. When the no-wake mode is activat- (1) Move the remote control levers back-
ed, “No Wake” will be displayed under ward so that the throttle is opened in re-
the boat speed. verse and both engines are operating at
the same engine speed.
NW N NE
(2) Increase the engine speed to 4500 rpm,
and then push the “CRUISE/NO WAKE”
SPEED
(+) button.
Once the reverse RPM control is activated,
pushing the “CRUISE/NO WAKE” (+) button
MPH
will increase the available engine speed by
No Wake approximately 500 rpm in 3 stages up to a
maximum of 6000 rpm, and pushing the
1 “CRUISE/NO WAKE” (–) button will decrease
the available engine speed. However, the ad-
1 “No Wake”
justment is limited to these 3 increments.
The no-wake mode can be set to 3 engine To deactivate the reverse RPM control:
speeds. To adjust the engine speed while the Operate the remote control levers to de-
no-wake mode is activated, push the crease the engine speed to less than 4500
“CRUISE/NO WAKE” (+) button or rpm.
“CRUISE/NO WAKE” (–) button.

73