Page 104 - LIT-18626-13-01

SportsBoat_F6H10.book Page 97 Tuesday, January 19, 2021 5:51 PM

Pre-operation checks

yard) may not pull free when the operator
1 falls off, allowing the boat to continue to
run and cause an accident.

NAV/ANC CTSY MAP SPREADER LIVEWELL
LIGHTS LIGHTS LIGHTS LIGHTS

1 Navigation and anchor lights switch

(2) Push the lower side of the navigation and
anchor lights switch and check that only Post-launch checks
the anchor light comes on. Perform the post-launch checks in the pre-
(3) Put the navigation and anchor lights operation checklist while the boat is in the
switch in the middle position and check water and the engines are running.
that the bow light and anchor light are
off. Engine shut-off switch check
Check the engine shut-off switch for proper
Horn switch check operation.
Push the horn switch and check that the horn (1) Start the engines. (See page 100 for in-
sounds. formation on starting the engines.)
(2) Pull the engine shut-off cord (lanyard) to
1 remove the clip from the engine shut-off
switch to make sure that the engines
stop immediately.
(3) Make sure that the engines cannot be
AFT RAW WATER FRESHWATER BILGE HORN
started with the clip removed from the
LIVEWELL WASHDOWN WASHDOWN
engine shut-off switch.

1 Horn switch
Engine shut-off cord (lanyard) check
Make sure that the engine shut-off cord (lan-
yard) is not damaged. If the cord is damaged,
replace it. WARNING! Never try to repair
the engine shut-off cord (lanyard) or tie it
together. The engine shut-off cord (lan-

97