Page 57 - LIT-18626-12-95

Instrument operation

z While the cruise assist is activated, the en- The no-wake mode can be set to 3 engine
gine speed can also be adjusted by operat- speeds. To adjust the engine speed while the
ing the remote control levers. no-wake mode is activated, push the
“CRUISE/NO WAKE” (+) button or
To deactivate the cruise assist: “CRUISE/NO WAKE” (–) button.
Operate the remote control levers to de- To deactivate the no-wake mode:
crease the engine speed to 3000 rpm or less. Perform one of the following operations.
When “Cruise” and the cruise assist setting z Push the “CRUISE/NO WAKE” (–) button
level disappear, the cruise assist is deactivat- repeatedly until “No Wake” disappears.
ed. z Push the remote control levers forward to
open the throttle.
Operating the boat with a minimal
wake (no-wake mode) Operating the boat in reverse with
The no-wake mode is useful for operating the more thrust (reverse RPM control)
boat at a steady speed with a minimal wake. Engine speed in reverse is limited to approx-
This is especially convenient when traveling imately 4500 rpm. If more thrust is required
in harbors, channels, or other areas posted when the boat is traveling in reverse, use the
with low speed limits as “no wake zones”. reverse RPM control. WARNING! Be pre-
The no-wake mode can be used only when pared to reduce throttle as soon as the
the engines are operating at idle speed. boat moves as desired. Otherwise, the
To activate the no-wake mode: boat may become unstable, which could
(1) Put the remote control levers in the TDE result in loss of control and an accident.
position or forward position so that both To activate the reverse RPM control:
engines are operating at idle speed. (1) Move the remote control levers back-
(2) Push the “CRUISE/NO WAKE” (+) but- ward so that the throttle is opened in re-
ton. When the no-wake mode is activat- verse and both engines are operating at
ed, “No Wake” will be displayed under the same engine speed.
the boat speed. (2) Increase the engine speed to 4500 rpm,
and then push the “CRUISE/NO WAKE”
SE S SW
(+) button.
Once the reverse RPM control is activated,
pushing the “CRUISE/NO WAKE” (+) button
will increase the available engine speed by
approximately 500 rpm in 3 stages up to a
MPH maximum of 6000 rpm, and pushing the
No Wake “CRUISE/NO WAKE” (–) button will decrease
the available engine speed. However, the ad-
1 justment is limited to these 3 increments.
1 “No Wake”

49